“
“Background Ferrite films have been widely used in computer memory chips, magnetic recording media, frequency filters, and many branches of telecommunication and electronic engineering. In particular, Ni ferrite (NiFe2O4)

films with spinel structure were currently of great interest due to their high magnetic permeability, high resistivity, and low losses, making itself a promising material for high-frequency applications. TPCA-1 purchase Many methods have been carried out to fabricate ferrites, such as molecular beam epitaxy [1], pulsed laser deposition [2, 3], spin-spray [4, 5], sol–gel [6], electrochemical deposition [7], direct liquid phase precipitation [8], hydrothermal growth [9, 10], and sputtering [11, 12]. Researches on structural and magnetic properties

of ferrites have been devoted recently. Li et al. [11] have reported that NiZn ferrite can be fabricated under low temperature. However, the magnetic properties of NiZn ferrite films fabricated under low temperature were not as good as bulk status, BTK inhibitor in vitro usually amorphous or with high coercivity (H c) and low saturation magnetization (M s) [11]. Usually, high-temperature post-heating treatments or in-situ heating was needed to obtain a better spinel structure and soft magnetic property [11]. But heating treatment was detrimental to the electric circuit integrations, which limited the applications of ferrite films as promising materials for high-frequency devices. Therefore, it was significant to investigate the effect of DMXAA order growth at room temperature (RT) on the structure

and magnetic properties of ferrite films. In this work, Ni ferrite films with different thicknesses (10, 50, 100, 500, and 1,000 nm) PJ34 HCl were fabricated under RT. Structure and magnetic properties were investigated as functions of thickness. Note that the 10-nm film showed superparamagnetism, different from the other samples (ferromagnetism), which was believed to be caused by the disordered layer discovered by transmission electron microscopy (TEM). Methods NiFe2O4 ferrite films were deposited onto 20 mm × 20 mm Si(111) substrates attached to a water-cooling system by radio frequency magnetron sputtering with a base pressure below 5 × 10-5 Pa. The mixed gas of argon and oxygen was used as the sputtering gas at total pressure of 2.5 Pa. The sample thickness was controlled by deposition duration. The crystal structure was checked by X-ray diffraction (XRD; X’Pert PRO PHILIPS (Almelo, Netherlands) with CuKα radiation). The images of the surface microstructure were taken using a field emission scanning electron microscope (SEM; S-4800, Hitachi, Ltd., Tokyo, Japan). The magnetic properties were measured using the MPMS magnetometer based on a superconducting quantum interference device (SQUID). The micrograph of the cross-section of the 500-nm NiFe2O4 film was taken by TEM (Tecnai TMG2F30, FEI, Hillsboro, OR, USA). Results and discussion XRD analysis was performed at RT after the films were fabricated.