Similarly to Figure 4, the plots present values averaged from several measurements made on three different samples evaporated at each temperature. Surprisingly, in 10-nm-thick films in the whole range of temperatures 200 to 350 K, adhesive forces between Ag adatoms and Ge wetting layer dominate over cohesive forces in silver. Thus, the temperature-dependent mobility of Ag adatoms does not deteriorate significantly the surface smoothness. RMS roughness values from tapping-mode AFM measurements of 10-nm Ag films are in agreement with those obtained using

XRR. An example of XRR data obtained for the 10-nm-thick Ag film deposited on 1-nm Ge interlayer and a fitted model are shown in Figure 7. The average film thickness measured HDAC inhibitor using XRR is 10.9 ± 1.1 nm and differs up to 10% from the buy C188-9 values controlled with calibrated quartz weight installed in the vicinity of substrates in the vacuum chamber of the e-beam evaporator. In single-layer structures, e.g., plasmonic silver lenses [28, 29], such fabrication

inaccuracies should less deteriorate performance than in the case of metal-dielectric-layered flat lenses [30–32]. Figure 6 Ten-point and average height values measured on 3 × 3 μm 2 area on 10-nm Ag films. Thin films were deposited at temperatures in the range 200 to 350 K, and RMS values were measured using both AFM and XRR. Figure 7 XRR data and fitted model for 10-nm Ag and 1-nm Ge film on sapphire substrate. At the end, we investigated the interior structure of 10-nm-thick samples using one-dimensional XRD. The dependency between grain size and the substrate temperature is presented in Figure 8. Again, the samples evaporated at temperatures close to RT have the best uniformity. Figure 8 Grain sizes measured using one-dimensional XRD. Ag films of 10-nm thickness were deposited at temperatures in the range 200 to 350 K. Conclusions A new sublimation-pressure empirical equation valid in the range from 50 K to T t = 273.16 K of the triple point helps Urocanase https://www.selleckchem.com/products/q-vd-oph.html select the optimum temperature in high-vacuum physical vapor deposition systems. We have demonstrated the possibility

to fabricate ultrasmooth metal nanolayers deposited onto epi-polished substrates at the lowest achievable pressure and at such a temperature that the whole dynamic range of both parameters is located on the gas side of the phase-boundary curve of water in a p-T diagram. The temperature range 230 to 350 K is established as the optimum for deposition of Ag nanolayers using e-beam evaporators. For the 10-nm Ag film on 1-nm Ge interlayer deposited at RT on sapphire substrate, a surface roughness with RMS = 0.22 nm has been achieved. For 30-nm-thick Ag films on sapphire substrate with 1-nm Ge wetting layer, RMS increases up to 0.49 nm. The ten-point height parameter given by extreme local surface features, which reflects scattering properties, has its minimum at 295 K.